Source-backed diagnostic reference

B1614 Code: Meaning & Diagnostic Guide

Wiper Rear Mode Select Switch Circuit Short To Ground

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does B1614 mean?

  • OTHER: Wiper Rear Mode Select Switch Circuit Short To Ground Source

B1614 quick answer

B1614 is listed as “Wiper Rear Mode Select Switch Circuit Short To Ground.” It indicates a detected electrical fault in the rear-wiper mode-select switch circuit, but the exact meaning and test procedure can vary by vehicle.

Is B1614 generic or manufacturer-specific?

B1614 currently has manufacturer-labelled reference definitions for OTHER. A universal generic definition is not asserted here. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How B1614 works in the vehicle

In this description, “short to ground” means the circuit may be connected to vehicle ground when it should not be. B1614 is a body-system code; the supplied reference does not identify a specific vehicle or confirm which component has failed.

B1614 symptoms

Depending on the vehicle and the fault, the rear wiper may not work, may operate intermittently, or may not respond correctly to mode selections. These symptoms do not by themselves confirm B1614 or a particular failed part.

Possible causes of B1614

Possible causes include damaged or chafed wiring, a poor or contaminated connector, a faulty rear-wiper mode switch, or another issue in the control circuit. Diagnosis is needed to identify the cause.

How to diagnose B1614

  1. Confirm the code with a compatible scan tool and note any other stored codes.
  2. Check the vehicle-specific service information for the exact B1614 definition and circuit test procedure.
  3. Inspect accessible rear-wiper switch wiring and connectors for visible damage, corrosion, looseness, or moisture.
  4. Have the circuit tested against the vehicle’s wiring diagram; do not replace parts based on the code alone.
  5. Clear the code only after any identified issue is addressed, then check whether it returns.

How to fix B1614

The repair depends on test results and may involve correcting wiring or connector damage, or replacing a component that testing confirms is faulty. Use vehicle-specific service information or consult a qualified technician.

Can I drive with B1614?

If the rear wiper is not working, rear visibility may be reduced in rain, snow, or spray. Adjust driving to conditions and avoid driving when visibility is inadequate.

B1614 frequently asked questions

Does B1614 prove the rear-wiper switch is bad?

No. The code describes a short-to-ground condition in the rear-wiper mode-select switch circuit; it does not confirm which component or wiring has caused it.

Can B1614 have a different meaning on another vehicle?

Yes. The supplied reference gives a general description, and code definitions and diagnostic procedures can vary by vehicle.

Can I keep driving with B1614?

Driving suitability depends on conditions and whether rear visibility is affected. Use caution when visibility is reduced and arrange diagnosis.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.