Source-backed diagnostic reference

P0379 Code: Meaning & Diagnostic Guide

Timing Reference High Resolution Signal B No Pulses

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P0379 mean?

  • GENERIC: Timing Reference High Resolution Signal B No Pulses Source
  • GENERIC: Timing Reference High Resolution Signal B No Pulses Source

P0379 quick answer

P0379 is a generic powertrain code meaning the engine computer detected no pulses from the high-resolution timing reference signal B. The code identifies a signal problem, not a confirmed failed part.

Is P0379 generic or manufacturer-specific?

P0379 has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P0379 works in the vehicle

A timing reference signal provides information the engine computer uses to track engine timing. “No pulses” means the expected repeating signal was not detected during the conditions monitored. The precise meaning of signal B and the circuit involved can vary by vehicle.

P0379 symptoms

Depending on the vehicle and fault conditions, possible symptoms include hard starting, stalling, rough running, reduced performance, or an illuminated check-engine light. A vehicle may also show no obvious symptoms.

Possible causes of P0379

Possible causes include an interruption or poor connection in the relevant wiring, a problem with the signal source or related circuit, or an issue with the engine computer. These are possibilities to investigate; P0379 alone does not identify the cause.

How to diagnose P0379

  1. Record P0379 and any other stored or pending codes, along with freeze-frame information if available.
  2. Check the vehicle-specific service information to identify signal B and the applicable diagnostic procedure.
  3. Inspect accessible connectors and wiring in the relevant circuit for damage, looseness, corrosion, or poor contact.
  4. Have a qualified technician test the circuit and signal using the vehicle manufacturer's procedure before replacing parts.
  5. Clear the code only after repairs or checks, then verify whether it returns under appropriate test conditions.

How to fix P0379

Repair any verified wiring or connection fault, or address another cause confirmed by testing. Do not replace a sensor or control module based on P0379 alone; follow vehicle-specific service information or consult a qualified technician.

Can I drive with P0379?

Driving impact can vary. If the engine stalls, runs poorly, or is difficult to start, avoid continued driving and arrange an assessment. If there are no symptoms, have the code checked promptly and use the vehicle's manual and professional advice to judge whether it is appropriate to drive.

P0379 frequently asked questions

What does P0379 mean?

It means the engine computer detected no pulses from the high-resolution timing reference signal B.

Does P0379 prove a sensor has failed?

No. It reports a missing signal, not a confirmed failed component. The circuit and its possible causes need to be tested.

Can I keep driving with P0379?

It depends on how the vehicle behaves. Stalling or poor running calls for avoiding continued driving; seek professional assessment if symptoms occur.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.