Source-backed diagnostic reference

P067B Code: Meaning & Diagnostic Guide

Cylinder 4 Glow Plug Control Circuit High

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P067B mean?

  • GENERIC: Cylinder 4 Glow Plug Control Circuit High Source
  • GENERIC: Cylinder 4 Glow Plug Control Circuit High Source

P067B quick answer

P067B is a generic diagnostic trouble code meaning “Cylinder 4 Glow Plug Control Circuit High.” It indicates that the engine control system detected a higher-than-expected electrical signal in the glow plug control circuit for cylinder 4; it does not, by itself, identify the failed part.

Is P067B generic or manufacturer-specific?

P067B has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P067B works in the vehicle

A glow plug helps warm a diesel engine’s combustion chamber, especially during cold starts. “Circuit high” describes the electrical signal detected by the control system, not necessarily a glow plug that is physically overheating. The exact test conditions and circuit design can vary by vehicle.

P067B symptoms

Possible symptoms include difficult cold starting, rough running shortly after startup, a warning light, or no noticeable change. Symptoms depend on the vehicle and operating conditions.

Possible causes of P067B

Possible causes include a glow plug or its wiring or connector, a problem with the glow plug control circuit, or an issue with the control module. The code alone does not confirm which, if any, of these is responsible.

How to diagnose P067B

  1. Confirm the code with a suitable scan tool and check for other stored codes.
  2. Consult vehicle-specific service information for the circuit layout and diagnostic procedure.
  3. Inspect accessible wiring and connectors for damage, corrosion, or loose connections.
  4. Have the glow plug circuit and its control components tested using the specified procedure and appropriate equipment.
  5. Recheck for codes after any confirmed fault is addressed.

How to fix P067B

Repair should be based on test results, not the code alone. A qualified technician can determine whether a glow plug, connection, wiring, or control component needs attention. Do not attempt hazardous electrical work or replace parts without confirming the cause.

Can I drive with P067B?

Driving impact varies. If the vehicle starts and runs normally, arrange diagnosis promptly and follow the owner’s manual. If it has trouble starting, runs poorly, or displays additional warnings, avoid relying on it until it has been checked.

P067B frequently asked questions

Does P067B mean the cylinder 4 glow plug has failed?

No. It identifies a high signal in the cylinder 4 glow plug control circuit, but further testing is needed to find the cause.

What does “circuit high” mean?

It means the control system detected an electrical signal above its expected range. It does not specify which component is at fault.

Can I keep driving with P067B?

The effect varies by vehicle and symptoms. Check the owner’s manual and arrange diagnosis, especially if starting or running is affected.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.