Source-backed diagnostic reference

P0907 Code: Meaning & Diagnostic Guide

Gate Select Position Circuit A High

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P0907 mean?

  • GENERIC: Gate Select Position Circuit A High Source
  • GENERIC: Gate Select Position Circuit A High Source

P0907 quick answer

P0907 is a generic powertrain code meaning “Gate Select Position Circuit A High.” It indicates that the circuit’s signal is higher than expected; the code alone does not identify a failed part.

Is P0907 generic or manufacturer-specific?

P0907 has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P0907 works in the vehicle

The gate select position circuit reports information about a gear selector’s position. “Circuit A High” describes an electrical signal reading above the expected range. The exact circuit design and diagnostic limits can vary by vehicle.

P0907 symptoms

Depending on the vehicle and the underlying issue, possible symptoms may include a gear-position warning, difficulty selecting gears, or unusual transmission behavior. Some vehicles may show no obvious symptoms.

Possible causes of P0907

Possible causes include a wiring or connector problem, an electrical supply or ground issue, a position sensor or switch fault, or a problem elsewhere in the circuit. P0907 by itself does not confirm any of these.

How to diagnose P0907

  1. Record the code and any related codes; note when the warning or symptoms occur.
  2. Check vehicle-specific service information for the circuit layout, expected readings, and test procedure.
  3. Inspect accessible wiring and connectors for looseness, corrosion, damage, or contamination.
  4. Use a suitable scan tool to compare gear-selector data with the actual selector position.
  5. Test the circuit according to the vehicle’s service procedure before deciding whether a component needs repair or replacement.

How to fix P0907

Base repairs on test results. Correct any verified wiring or connector issue, or address a confirmed faulty component using vehicle-specific procedures. Clear the code and verify the repair afterward; avoid replacing parts based on the code alone.

Can I drive with P0907?

Driving impact depends on the vehicle and its symptoms. If gear selection or transmission operation is abnormal, stop in a safe place and arrange professional diagnosis or recovery rather than continuing to drive.

P0907 frequently asked questions

Does P0907 mean the gear selector is faulty?

No. It identifies a high signal in the Gate Select Position Circuit A, but does not establish which part, if any, has failed.

Can P0907 cause shifting problems?

It may be associated with shifting or gear-selection concerns, but symptoms vary and are not confirmed by the code alone.

Can I clear P0907 without diagnosing it?

Clearing the code does not address its cause. Record the code and related information, diagnose the circuit, and verify any repair.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.