Source-backed diagnostic reference

P0948 Code: Meaning & Diagnostic Guide

Hydraulic Pump Relay/Control Circuit High

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P0948 mean?

  • GENERIC: Hydraulic Pump Relay/Control Circuit High Source
  • GENERIC: Hydraulic Pump Relay/Control Circuit High Source

P0948 quick answer

P0948 is a generic OBD-II code for “Hydraulic Pump Relay/Control Circuit High.” It indicates that the control circuit’s signal was higher than expected; it does not by itself confirm that the pump or relay has failed.

Is P0948 generic or manufacturer-specific?

P0948 has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P0948 works in the vehicle

The code concerns the electrical circuit used to control a hydraulic pump relay. “Circuit high” describes an unusually high electrical reading detected by the vehicle’s control system. The exact system design and diagnostic procedure can vary by vehicle.

P0948 symptoms

Possible symptoms depend on the vehicle and system. The code may appear with a warning light, altered operation of a related hydraulic function, or no obvious change in driving. These symptoms are not established by the code alone.

Possible causes of P0948

Possible areas to investigate include wiring or connector problems, a fuse or relay issue, a control-circuit fault, or a pump-related electrical problem. P0948 alone does not identify a confirmed failed component.

How to diagnose P0948

  1. Confirm the code with a compatible scan tool and note any other codes and available freeze-frame data.
  2. Check the vehicle-specific service information for the circuit layout and diagnostic procedure.
  3. Have the relevant wiring, connectors, fuse, and relay inspected for damage, corrosion, looseness, or other visible issues.
  4. If needed, have a qualified technician test the circuit and components using the vehicle-specific procedure before replacing parts.

How to fix P0948

Address the fault identified by testing rather than replacing the pump or relay based on the code alone. Repairs may involve correcting a wiring or connection issue or replacing a verified faulty component. Follow vehicle-specific service information and use a qualified technician when appropriate.

Can I drive with P0948?

The code alone cannot establish whether continued driving is safe. If a related function is not working normally or a warning indicates a serious problem, stop using that function and seek qualified assistance. Otherwise, arrange diagnosis promptly and follow the vehicle’s owner information.

P0948 frequently asked questions

Does P0948 mean the hydraulic pump has failed?

No. It identifies a high reading in the hydraulic pump relay/control circuit, not a confirmed pump failure.

Can a wiring problem trigger P0948?

Wiring or connector problems are possible areas to check, but diagnosis is needed to identify the cause.

Should I replace the relay when P0948 appears?

Not without testing. The code does not confirm that the relay is faulty.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.