Source-backed diagnostic reference

P122E Code: Meaning & Diagnostic Guide

BMW defines P122E as “NOx Sensor Binary Oxygen Sensor Signal Circuit/Open (Bank 1).” The code definition does not establish applicability to a 2021+ BMW BEV or PHEV.

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P122E mean?

  • GENERIC: BMW defines P122E as “NOx Sensor Binary Oxygen Sensor Signal Circuit/Open (Bank 1).” The code definition does not establish applicability to a 2021+ BMW BEV or PHEV. Source

P122E quick answer

P122E is described in the cited reference as “NOx Sensor Binary Oxygen Sensor Signal Circuit/Open (Bank 1).” This points to an open or interrupted signal circuit, but the code alone does not identify a failed part or confirm that the definition applies to a particular vehicle.

Is P122E generic or manufacturer-specific?

P122E has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P122E works in the vehicle

“Circuit/open” means the control system may not be detecting the expected electrical signal. “Bank 1” identifies one side of an engine’s cylinder arrangement; its location depends on the vehicle. The cited definition is BMW-specific, and it does not establish applicability to a 2021 or newer BMW BEV or PHEV.

P122E symptoms

The evidence provided does not establish symptoms. Depending on the vehicle and its systems, a warning light or an emissions-related message may occur, but neither is confirmed by this code reference alone.

Possible causes of P122E

The code description suggests a possible signal-circuit interruption. Wiring, a connector, the sensor, or another circuit issue could be considered during diagnosis, but the evidence does not confirm any of these as the cause.

How to diagnose P122E

  1. Confirm the vehicle’s year, model, powertrain, and exact stored code using a scan tool.
  2. Check manufacturer-specific service information to verify that P122E applies to that vehicle and learn what its control system monitors.
  3. Review related codes and available scan data before deciding which circuit or component to test.
  4. Have a qualified technician check the relevant signal circuit and connections using vehicle-specific procedures.
  5. Confirm the diagnosis and verify repairs with a follow-up scan; do not replace a sensor based on the code alone.

How to fix P122E

The correct repair depends on test results. A technician may need to address a circuit or connection problem, or replace a component if testing confirms it has failed. Avoid high-voltage work and use qualified service for electrified vehicles.

Can I drive with P122E?

The reference does not establish whether it is safe to drive with P122E. Follow the vehicle’s warning messages and owner’s manual, and arrange diagnosis. If the vehicle shows severe warnings, reduced power, or unusual behavior, stop in a safe place and seek professional assistance.

P122E frequently asked questions

What does P122E mean?

The cited reference defines it as “NOx Sensor Binary Oxygen Sensor Signal Circuit/Open (Bank 1).” It describes a possible signal-circuit issue, not a confirmed failed component.

Does P122E confirm a bad NOx sensor?

No. The code description alone does not identify the failed part. Circuit checks and vehicle-specific diagnostic information are needed.

Does this definition apply to every BMW, including BEVs and PHEVs?

No such applicability is established by the supplied evidence. Verify the code against service information for the exact vehicle.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.