Source-backed diagnostic reference

P1389 Code: Meaning & Diagnostic Guide

No Auto Shutdown (ASD) Relay Output Voltage At PCM

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P1389 mean?

  • DODGE: No Auto Shutdown (ASD) Relay Output Voltage At PCM Source
  • FORD: Glow Plug Circuit High Side Low Input Source
  • JEEP: No Auto Shutdown (ASD) Relay Output Voltage At PCM Source
  • LINCOLN: Glow Plug Circuit High Side Low Input Source
  • MERCURY: Glow Plug Circuit High Side Low Input Source
  • OTHER: Glow Plug Circuit High Side Low Input Source
  • PLYMOUTH: No Auto Shutdown ASD Relay Output Voltage At PCM Source
  • PONTIAC: No Auto Shutdown ASD Relay Output Voltage At PCM Source

P1389 quick answer

P1389 is a manufacturer-specific powertrain code, so its meaning depends on the vehicle. The supplied references associate it with missing Auto Shutdown (ASD) relay output voltage at the PCM on some makes, and a glow-plug circuit high-side low input on others. Check the exact vehicle’s service information before diagnosing.

Is P1389 generic or manufacturer-specific?

P1389 currently has manufacturer-labelled reference definitions for DODGE, FORD, JEEP, LINCOLN, MERCURY, OTHER and others. A universal generic definition is not asserted here. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P1389 works in the vehicle

PCM means powertrain control module. An ASD relay supplies power to engine systems on vehicles that use it; “no output voltage at the PCM” means the expected power was not detected there. A glow-plug circuit helps heat diesel engine cylinders for starting; “high-side low input” describes a signal or voltage reading below the expected level. These are different manufacturer-specific definitions, not interchangeable diagnoses.

P1389 symptoms

Depending on the vehicle and the underlying issue, a code with the ASD definition could occur alongside a no-start, stall, or other engine-running problem. With the glow-plug definition, difficult cold starting or increased starting time may be present. The code alone does not confirm any of these symptoms or identify a failed part.

Possible causes of P1389

Possible causes depend on which definition applies. An ASD-related interpretation may involve a power supply, fuse, relay, wiring, connector, or control issue. A glow-plug interpretation may involve its circuit wiring, connections, power supply, or control system. These are possibilities, not confirmed faults.

How to diagnose P1389

  1. Confirm the vehicle’s year, make, model, engine, and the exact P1389 description shown by a capable scan tool.
  2. Use manufacturer-specific service information to verify the code definition and diagnostic procedure for that vehicle.
  3. Record other stored codes and relevant freeze-frame data before clearing anything.
  4. Visually check relevant fuses, connectors, and wiring for looseness or visible damage; follow the vehicle-specific procedure for electrical tests.
  5. If the definition or test results are unclear, have a qualified technician continue diagnosis rather than replacing parts based on the code alone.

How to fix P1389

There is no single repair for P1389 across all vehicles. Repair decisions should follow the confirmed manufacturer-specific definition and test results. Address only the fault identified by those checks, then verify the repair using the vehicle’s prescribed procedure.

Can I drive with P1389?

Driving advice depends on the vehicle’s symptoms and the applicable code definition. If the engine stalls, will not start reliably, or runs abnormally, avoid continued driving and arrange professional assessment. If there are no symptoms, consult vehicle-specific guidance promptly rather than assuming the vehicle is safe or unsafe based on the code alone.

P1389 frequently asked questions

Does P1389 have the same meaning on every vehicle?

No. The supplied references list different meanings by manufacturer, including an ASD relay output-voltage description and a glow-plug circuit description. Confirm the definition for the exact vehicle.

Does P1389 prove the ASD relay or a glow plug has failed?

No. It reports a detected circuit condition, and the meaning varies by vehicle. Testing is needed to determine whether a component, wiring, connection, or another issue is involved.

Can P1389 cause a no-start?

A no-start could occur with some faults associated with the ASD description, while glow-plug circuit problems may affect cold starting on applicable vehicles. Neither symptom is guaranteed by the code.

What should I check first?

First confirm the vehicle-specific code description using a scan tool and manufacturer service information. Then follow the matching diagnostic procedure before deciding on a repair.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.