Source-backed diagnostic reference

P1488 Code: Meaning & Diagnostic Guide

Auxiliary 5 Volt Supply Output Too Low

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P1488 mean?

  • DODGE: Auxiliary 5 Volt Supply Output Too Low Source
  • JEEP: Auxiliary 5 Volt Supply Output Too Low Source
  • PLYMOUTH: Auxiliary 5 Volt Supply Output Too Low Source
  • PONTIAC: Auxiliary 5 Volt Supply Output Too Low Source

P1488 quick answer

P1488 is described in the supplied references as “Auxiliary 5 Volt Supply Output Too Low.” It indicates that an auxiliary 5-volt electrical supply is below its expected level; it does not identify a failed part by itself.

Is P1488 generic or manufacturer-specific?

P1488 currently has manufacturer-labelled reference definitions for DODGE, JEEP, PLYMOUTH, PONTIAC. A universal generic definition is not asserted here. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P1488 works in the vehicle

A 5-volt supply provides power or a reference signal for electronic components such as sensors. “Output too low” means the monitored voltage is lower than expected. The exact circuit and diagnostic procedure can depend on the vehicle.

P1488 symptoms

The check-engine light may be on when this code is stored. Other symptoms are not established by the supplied evidence and can vary; the code alone does not confirm a particular drivability problem.

Possible causes of P1488

Possible causes to investigate include a problem with a component using the auxiliary supply, damaged or shorted wiring, a poor electrical connection, or a supply-control issue. These are possibilities, not confirmed causes of P1488.

How to diagnose P1488

  1. Confirm the exact code and record any other stored codes and available freeze-frame data.
  2. Check the vehicle’s service information for the P1488 definition and test procedure applicable to its make, model, and year.
  3. Inspect relevant connectors and wiring for looseness, corrosion, damage, or signs of a short.
  4. Use the manufacturer’s diagnostic procedure to check the auxiliary 5-volt circuit and its connected components.
  5. If the cause is not clear, have a qualified technician diagnose the circuit before replacing parts.

How to fix P1488

Repair or replace only the component or wiring fault confirmed by testing, then clear the code and verify whether it returns. Do not assume a sensor or control module has failed based on P1488 alone.

Can I drive with P1488?

The supplied evidence does not establish a universal safety outcome. If the vehicle runs normally, arrange diagnosis soon and follow the owner’s manual. Stop in a safe place and seek assistance if it develops severe drivability problems or warning signs.

P1488 frequently asked questions

What does P1488 mean?

The supplied references define P1488 as “Auxiliary 5 Volt Supply Output Too Low.” It means the monitored auxiliary 5-volt supply is below its expected level.

Does P1488 identify a failed part?

No. It describes a low-voltage condition, not a confirmed failed component. Testing is needed to locate the cause.

Can I keep driving with P1488?

The evidence does not establish a universal answer. Consider the vehicle’s behavior and owner’s manual, and seek prompt diagnosis; stop safely if serious symptoms develop.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.