Source-backed diagnostic reference

P2013 Code: Meaning & Diagnostic Guide

Intake Manifold Runner Control Circuit High Bank 2

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P2013 mean?

  • GENERIC: Intake Manifold Runner Control Circuit High Bank 2 Source
  • GENERIC: Intake Manifold Runner Control Circuit High (Bank 2) Source

P2013 quick answer

P2013 is a generic powertrain code for an intake manifold runner control circuit reading high on Bank 2. It identifies an electrical signal outside the expected range, not a confirmed failed part.

Is P2013 generic or manufacturer-specific?

P2013 has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P2013 works in the vehicle

The intake manifold runner control system changes airflow through the intake manifold. P2013 means the engine computer detected a higher-than-expected signal in that system’s circuit for Bank 2. Bank 2 refers to the side of the engine that does not contain cylinder 1, where the engine has two banks.

P2013 symptoms

Some vehicles may show a check-engine light, reduced performance, rough running, or changes in fuel economy. A vehicle may also have no obvious symptoms. These possibilities depend on the vehicle and the underlying cause.

Possible causes of P2013

Possible causes include a wiring or connector problem, a circuit short, a control-system issue, or a problem with the runner mechanism or its actuator. The code alone does not identify which, if any, of these is responsible.

How to diagnose P2013

  1. Confirm the code with a suitable scan tool and check for other stored codes and relevant freeze-frame data.
  2. Use vehicle-specific service information to locate the Bank 2 runner-control circuit and identify its expected operation.
  3. With the engine off, inspect accessible wiring and connectors for damage, corrosion, loose connections, or signs of contact with hot or moving parts.
  4. Have a qualified technician test the circuit and runner-control system against the vehicle’s specifications before replacing parts.

How to fix P2013

The repair depends on test results. It may involve correcting a wiring or connector issue, addressing a control-circuit fault, or repairing a confirmed problem with the runner mechanism or actuator. Avoid replacing parts based on the code alone.

Can I drive with P2013?

P2013 does not establish a universal level of driving risk. If the vehicle runs poorly, loses power, or displays other warning signs, limit driving and arrange an inspection. Follow the vehicle’s owner’s manual for warning-light guidance.

P2013 frequently asked questions

What does P2013 mean?

It indicates that the intake manifold runner control circuit for Bank 2 has been detected as high, meaning its signal is above the expected range.

Does P2013 confirm a failed intake manifold runner actuator?

No. The code points to a circuit condition but does not confirm which component or wiring issue, if any, caused it.

Can I keep driving with P2013?

Driving impact varies by vehicle and symptoms. Use the owner’s manual and have the code diagnosed, especially if performance is affected.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.