Source-backed diagnostic reference

P2405 Code: Meaning & Diagnostic Guide

EVAP System Leak Detection Pump Sense Circuit Low

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does P2405 mean?

  • GENERIC: EVAP System Leak Detection Pump Sense Circuit Low Source
  • GENERIC: EVAP System Leak Detection Pump Sense Circuit Low Source

P2405 quick answer

P2405 means the EVAP system leak-detection pump sense circuit is reporting a voltage lower than expected. The code identifies a circuit condition; it does not, by itself, confirm that the pump has failed.

Is P2405 generic or manufacturer-specific?

P2405 has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How P2405 works in the vehicle

EVAP is the evaporative-emissions system, which manages fuel vapors. The sense circuit carries information used to monitor the leak-detection pump. “Circuit low” means the reported electrical level is below the expected range. The cause needs diagnosis on the specific vehicle.

P2405 symptoms

There may be no noticeable change in how the vehicle runs. A check-engine light or an emissions-test issue is possible, but neither is guaranteed by this code alone.

Possible causes of P2405

Possible causes include a wiring or connector problem, an issue with circuit power or ground, a fault involving the pump’s sense circuit, or a control-system issue. These are possibilities, not confirmed failures.

How to diagnose P2405

  1. Confirm P2405 with a suitable scan tool and review any available freeze-frame information.
  2. Consult vehicle-specific service information for the circuit layout and test procedure.
  3. Inspect accessible related wiring and connectors for looseness, damage, or corrosion.
  4. Have a qualified technician test the circuit and its power, ground, and signal as specified by the service procedure.
  5. Use test results to identify the cause, then clear the code and check whether it returns.

How to fix P2405

Repair should follow the diagnosis and vehicle-specific service information. Do not replace the leak-detection pump based on P2405 alone; the code does not identify a confirmed failed component.

Can I drive with P2405?

This code alone does not establish whether a vehicle is safe or unsafe to drive. Check the owner’s manual and seek professional advice if warning lights, drivability changes, or other concerns occur.

P2405 frequently asked questions

What does P2405 mean?

It indicates a low electrical reading in the EVAP leak-detection pump sense circuit.

Does P2405 mean the leak-detection pump is bad?

No. It identifies a circuit condition, not a confirmed failed pump. Wiring, connections, or other circuit issues may also need to be checked.

Can P2405 cause symptoms?

Some vehicles may show a check-engine light or have an emissions-test issue, while others may have no obvious symptoms.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.