Source-backed diagnostic reference

U0008 Code: Meaning & Diagnostic Guide

High Speed CAN Communication Bus (-) High

Reference status: This page preserves source-backed code definitions for discovery. Manufacturer/model applicability, repair steps and safety conclusions are not treated as verified unless a manufacturer-specific verified report is available.

What does U0008 mean?

  • GENERIC: High Speed CAN Communication Bus (-) High Source
  • GENERIC: High Speed CAN Communication Bus (-) High Source

U0008 quick answer

U0008 is a generic network trouble code meaning “High Speed CAN Communication Bus (-) High.” It indicates that the vehicle’s control system detected a high condition on the negative line of the high-speed CAN communication bus; it does not identify a confirmed failed part.

Is U0008 generic or manufacturer-specific?

U0008 has a generic source-backed definition in this database. The exact vehicle make, model, year and powertrain should be confirmed before using a definition for diagnosis.

How U0008 works in the vehicle

CAN is a communication network that lets vehicle control modules exchange information. “(-) High” describes the condition reported for the bus’s negative line. The code alone does not establish why the condition occurred or which module or circuit is responsible.

U0008 symptoms

Depending on the vehicle and whether communication is affected, possible context may include warning lights, stored communication codes, or features that do not work as expected. Some vehicles may show no obvious symptoms.

Possible causes of U0008

Possible causes include a wiring or connector problem, an issue affecting the network, or a control module or other electrical fault. These are possibilities only; U0008 does not confirm any specific cause.

How to diagnose U0008

  1. Confirm U0008 with a suitable scan tool and note whether it is current or stored.
  2. Check for other codes and record which modules report communication problems.
  3. Look up the vehicle-specific diagnostic information, since test procedures and network layouts vary.
  4. Have a qualified technician inspect relevant wiring and connectors and test the network using the specified procedure.
  5. Verify the repair by clearing codes as appropriate and checking whether U0008 returns.

How to fix U0008

The repair depends on the cause confirmed during diagnosis. Address the identified wiring, connector, network, or module issue using vehicle-specific service information. Do not replace a component based only on this code.

Can I drive with U0008?

U0008 alone does not determine whether the vehicle is safe to drive. If warning lights, loss of important functions, or drivability problems occur, seek professional assessment and follow the vehicle’s manual. If the vehicle behaves normally, arrange diagnosis rather than assuming the code is harmless.

U0008 frequently asked questions

Does U0008 identify a failed part?

No. It reports a high condition on the negative line of the high-speed CAN bus, but further diagnosis is needed to identify the cause.

Can U0008 cause warning lights or communication problems?

Possibly. Effects depend on the vehicle and whether the network or connected modules are affected; some vehicles may show no obvious symptoms.

Can I diagnose U0008 from the code alone?

No. The code is a starting point. Other stored codes, vehicle-specific service information, and network testing may be needed.

Search variants and canonical URL

Capitalization, underscores, hyphens, colons and spaces are normalized to this canonical code identity so alternate scan-tool formats do not create duplicate pages.